Bandje voor Signature 12

Pro-Ject

Accessoires voor platenspelers | Riemen en riemschijven

Original replacement strap for the Project Signature 12 turntable platter drive Round strap suitable for turntables: O 2 mm / O 304 mm SIGNATURE 12 This long belt is designed to drive the platter drive of the Pro-Ject Signature 12 turntable. The turntable has two drive motors, so when replacing the belt, we recommend replacing...

Meer ID: 275021 EAN: 8595122733490

Status

Nieuw

Beschikbaarheid

Bij uitgever

Verwacht op

Prijs

10,29 €

Prijs is inclusief BTW 21 %

Beschikbaarheid

Bij uitgever

Verwacht op

Kerstlevering:

Bij artikelen die onze directe leverancier niet op voorraad heeft, of bij artikelen die we uit het buitenland importeren, kunnen we in de kerstperiode helaas geen levering voor Kerstmis garanderen.

Original replacement strap for the Project Signature 12 turntable platter drive

Round strap suitable for turntables:

O 2 mm / O 304 mm

SIGNATURE 12

This long belt is designed to drive the platter drive of the Pro-Ject Signature 12 turntable. The turntable has two drive motors, so when replacing the belt, we recommend replacing the pair of short belts designed to transfer power from the motor pulley at the same time.

Note: If your turntable is not one of the models listed, please refer to the configuration chart in the download section for the appropriate belt.

All Pro-Ject drive belts are made from the highest quality materials and are optimized for specific model series of Pro-Ject turntables.

To extend the life of the drive belt, never touch it with your hands.When installing or manually changing the speed, use the special plastic wrench (supplied as a standard accessory with Pro-Ject turntables) and install the belt using the key on the pulley.

WHEN IS IT NECESSARY TO CHANGE THE STRAP?

Every turntable with a belt drive requires regular belt replacement. Exactly when this replacement is necessary depends on several circumstances such as environmental influences, frequency of use, etc.If you notice that the turntable is not reaching full speed, not maintaining the correct speed, fluctuating or cannot switch the rotation speed, it is time for the belt to reach its life limit.
To prevent these symptoms, a regular check of the belt is necessary. Remove the strap from the turntable and slightly tighten it. A good quality strap should not show any slight distortion of cohesion. If you see any cracks, it means that the strap has dried out over time and timely replacement is necessary.
If you do not use the turntable regularly and after a period of prolonged inactivity, the strap may stretch or break spontaneously.The belts dry out and age spontaneously and this process cannot be stopped. High temperatures and humidity have a major effect on the life of the belts. Regular strap replacement is thus a necessity and a guarantee of quality sound.
However, when replacing the strap, it is necessary to keep the original specification and most importantly - the same shape and dimensions of the strap.It is not possible to change from a square strap to a round one or otherwise.A different shape would not be adapted to the pulley (motor drive axis) of the turntable and, as a result of the different contact area, the rotation of theThe rotation speed would not be correct and the friction could cause increased wear or breakage of the belt.